The Forbidden Object

I’ve been at odds for over a week with a small plastic object that apparently has, encoded in its folds, some devilish conflict with the laws of physics and sacred geometry of the universe

that

makes

it

ENTIRELY

unprintable.

It’s not even that tricky, it’sjust a little box for an r/c receiver, but so far I’ve tried it on two different printers and every time it just curls into a ball of fail.

First layer on blue tape… OK! Looking good, this one’s gonna be perfect aaand

Blaaaarrrggghhh

Ok fine let’s try with the bed hotter, looking good so far, hey wait STEPPER DRIVER ERROR JET PIPE OVERHEAT DUMPING CORE

one cooling duct and blower for the Trigorilla board later

What the deuce? Now the skirt lifts and I get all sorts of unhappy noises from the extruder??

It was about at this point that I grabbed the top of the effector and shook it very gently and it rocked about like a pendulum. I looked and saw that all three linear guides on the towers were not moving, so I grabbed my hex keys and started going around to all the bolts. I found a couple loose by about a whole turn. Now there’s a peculiar offset so I ran the DELTA_CALIBRATE again…

Will I ever get the FORBIDDEN CURSED OBJECT to print? Stay tuned for either a post of blissful success or me giving up and printing it ass over teakettle on breakaway supports.

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.